Product#: DR124

1980-95 GM; 6/8 Cylinder; Ignition Control Module; 7-Pin

OE Quality Control Modules for Electronic Ignition Vehicles. {fitment}

Product#: D1110A

1957-67 Chevrolet; Ignition Coil Ballast Resistor; Original Style; 1.8 Ohms; Features Delco Remy Logo and 1/2-moon Stamp in the Bracket

Reproduction ignition coil resistor for 1957-67 Chevrolet passenger car models. Fits 6 or 8 cylinder (excluding high performance). Features correct 1.8 ohm rating for standard models without high performance engine. Features...

Product#: D1111

1955-64 Chevrolet Ignition Coil Ballast Resistor; 0.3 Ohms; Features Delco Remy Logo, 1/2-moon Stamp in the Bracket and the Black Dot

Replace your original ignition coil resistor with this high quality reproduction piece. This OE replacement will offer years of service and long lasting dependability. Features Delco Remy logo, correct 1/2-moon notch on the...

Product#: D72000

Pertronix Flame Thrower III HEI Performance Module - 4 Pin

Upgrade/replacement Flame Thrower III module for 8 cylinder automotive Pertronix billet distributors. These distributor modules are direct bolt-in replacements for your Pertronix Flame Thrower III distributor. Installed...

Product#: D1110

1955-56 Chevrolet Ignition Coil Ballast Resistor; Original Style; 1.8 Ohms; Features Delco Remy Logo and Smooth Bracket

Reproduction ignition coil resistor for 1955-56 Chevrolet passenger car models. Fits 6 or 8 cylinder (excluding high performance). Features correct 1.8 ohm rating for standard models without high performance engine. Features...

Product#: D1111A

1962-64 Impala, Bel Air, Biscayne, Corvette; Ignition Coil Ballast Resistor; 0.3 Ohms; Features Delco Remy Logo, Square Stamp in the Bracket and the Black Dot

Replace your original ignition coil resistor with this high quality reproduction. This OE replacement will offer years of service and long lasting dependability. Features Delco Remy logo, correct square notch on the side of...

Product#: 84661

MSD; Magnetic Pickup; Replacement For All MSD Billet Dististibutors

The MSD Magnetic Pick-Up replacement is the same high output assem­bly that is currently found in all MSD Distributors. It is supplied with the two pin connector installed. NOTE: No further discounts apply.